[RABTECH]

I noticed my seatbelt was hard to pull out and even more difficult to get back in. I investigated and found this. It had come thru this gap and was between the plastic and the top of the storage compartment.

 

[Kip]

You're saying it was installed through the wrong section of the bodywork?

 

[RABTECH]

No , i don't think so. There is a gap in the center of the hole so that when they install the seat belt they can put the belt in the slot its supposed to be in. However, it is clear now that it will go back thru the slot and be between the plastic and the storage compartment. Just another thing to look out for . You will know because the seat belt is slow to retract and harder to pull out. just thread it back down the slot to the correct hole.

You can see in my picture the belt hiding thru the slot that causes it to slide out of place..

 

[NightFlyer]

Is this just a drivers side issue?

 

[RABTECH]

Is this just a drivers side issue?

I had to go inside for a few minutes. Ill check and get right back to ya on that...

 

[RABTECH]

Is this just a drivers side issue?

Looks like the passenger side could slide up the gap also.

 

[NightFlyer]

Thx


Sent from my iPhone using Tapatalk