Polaris Slingshot Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
63 Posts
Discussion Starter #1
Hi everyone trying to jump in here smoothly some of my new found knowledge
the oil filter Is a composite material it is very similar to the 6 L Ford diesel engine, Ford was up top you could use a 3 foot monkey wrench accessibility was great caution do not use that size.
The offset wrench will be a joy to use I have a suggestion in lifting the vehicle. There are four points Polaris recommends for left, if you had 4 low profile three Ton rolled Jacks they sell for about $89 each will be able to operate two of the jacks on each side. Use a little piece of carpet or rubber matting three pumps on one side then move to the other side when you are done you ss will be about 19 inches off the ground and level. Couple of Jack's stance and you would be able to drain oil, manual transmission, and beveled gear drive. You would not do this for just a oil change, would be great for a big service.I'm partial to this idea because I already have three of these jacks. Now if I can get a slingshot I'll take some pictures.
 
1 - 2 of 2 Posts
Top