Polaris Slingshot Forum banner

1 - 10 of 10 Posts

·
Premium Member
Joined
·
2,216 Posts
Discussion Starter · #1 ·
The Polaris Slingshot already has that sinister look at night.. these Demon Eyes take that look to an entirely different level of awesomeness. This kit is offered in two trim levels for both the U.S. (two headlight setup), and the U.S. Model with our Optional Canadian Conversion Kit (four headlight setup). You'll simply plug in the colored LED T10 bulbs and run the included power harness to your power distribution block and you're done. This kit does not replace your headlight. The H3 headlight housing on both the U.S. and Canadian Conversion Kit have a small factory incandescent LED T10 bulb on the bottom of each headlight assembly. You'll simply be replacing that factory T10 bulb with our colored T10 LED bulb for the demon eye affect. Installation time is about 1 hour. The system also includes an RF remote control to allow you to control the dim levels as well as function through some flashing sequences.

Polaris Slingshot LED Demon Eyes Headlight Accent Kit

Currently on a back order, orders will start shipping out the first week of January! ;)



We have exclusive promo code going right now just for forum users. Use promo code: "demon10" and that will save you 10%! :D

 

·
Premium Member
Joined
·
2,216 Posts
Discussion Starter · #3 ·
@RandyMaria Hey Randy, what complications did you run into during the install? Would love to help you out with this. do you already have a aftermarket fuse block or will be installing one?
 

·
Registered
Joined
·
474 Posts
Did not use SlingMod's kit but did it on my own, how hard could it be??? Pull out the plug, pop in the LED and connect a couple wires.
 

·
Hold my beer and watch this!
Joined
·
1,319 Posts
Helped a friend on the other forum install his and didn't even really need the instructions. Just checked them to make sure all the equipment was in the box. Was a walk in the park.
 

·
Registered
Joined
·
1,242 Posts
I just finished my install and felt that the instructions were pretty deficient on the loosening of the headlight housing to get access to the cans. Just a couple words (instead of cheesy music) in the install videos would be extremely helpful. Remove this. Loosen this. Drop this. etc. I did figure it out after pausing several times.

Side note: I also separated my halos to outer and inner so I can run all 4 with the headlights and outer only with the demon eyes.
 
1 - 10 of 10 Posts
Top