Polaris Slingshot Forum banner

My quickest, but not cheapest, cup holder heat solution

3K views 4 replies 4 participants last post by  Sling ding-a-ling 
#1 ·
I was at the boat supply store and saw these 10 oz Yeti highball tumblers and thought they looked almost exactly the same size as the cup holders in my 2017 base Slingshot. Bought them and when I popped the old cup holder out, they almost fit but just too tight to force in. My solution: I grabbed my heat gun and made a few passes around the lip of the hole and then squeezed the yeti into the hole. When the plastic cooled, it made a great seal and it is in there. My big yeti even sits inside pretty firmly. They were $19.95 each but pretty sure there will be no heat issues for my cold drinks when summer rolls around again (although it's still pretty warm here at the beach now).
 

Attachments

See less See more
5
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top