Polaris Slingshot Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
86 Posts
Discussion Starter #1
after taking delivery I noticed a small indentation on the hood at the base of the hood "vent". Not very noticeable. Much more prominent in the pictures. not perfectly symmetrical so I am sure it is a defect. think it may be caused by the screw under the hood (holding "vent") screwed too tight. neighbor (gear head) thinks it may be from engine heat. either way annoying...but I hope that Polaris will take care of it.

Passenger seat is also shifted slightly to passenger side. headrest is not centered in front of roll bar. minimally off but off nonetheless.

stiil absolutely love it. base with all the extras. upgraded wheels are waiting on software update from Polaris.
 

Attachments

·
Registered
Joined
·
1,207 Posts

Id say both seats are slightly outboard of dead center cant see the dimple /dent /imperfect.
 
1 - 2 of 2 Posts
Top